Conventional Wellhead
- Wellhead Housings
- Casing Hangers
  - W1
  - W1-M
  - W2
  - W6
- Secondary Seals
- Tubing Hangers/Adapters
- Control Line Exit Blocks
  - DHCV
Time Saving Solutions
- W2 with S4 Surelok
- SCH1
- S95
- SH2
- SH3
- LSH
- OSH
- MWC
- Slip Clamp
Connectors
- SRC
- LRC
- USC
- S4
Flow Control
- Gate Valves
- Actuators
- Pressure Reduction
  - MOS Choke
  - PRS
  - SES
- Presco-Switches
  - Presco-Switch
  - DHTE Presco-Switch
- Presco-Pilots
  - 2-Line
  - 3-Line
- Presco-Pumps
  - Low Pressure
  - High Pressure
- Presco Control Panels
  - Presco Control Panel
Frac Solutions
Rigsaver™

P Elastomer Seal

The P Seal is an elastomer seal comprised of an injectable, molded seal ring flanked by two anti-extrusion rings. A single seal is recommended for pressures up to 5,000 psi. When used in a double seal configuration, and depending on the size of the seal, the Double P seal can be rated up to 15,000 psi.

This easy to install, reliable and field-proven design is one of WGPC's standard, integral, elastomer seals offered with conventional equipment.

Features –

Metal anti-extrusion rings on each side:
- Protect the seal from high pressure loads.
- Hold the ring in position for easy installation over casing.
Bidirectional seal
Available for use over casing/tubing sizes from 2-7/8" through 26"
Suitable for use in temperatures from 0°F to +250°F (-18°C to +121°C)
Available in materials suitable for sour or corrosive service where high levels of CO₂ and H₂S are present.